Electrical Insulation and Switchgear

Low-ionic pigment pastes for insulating profiles, switchgear components, transformer parts and high-voltage protective coatings.

Inside of a switchgear cabinet showing cast epoxy insulating components and busbars

Insulating components are specified on electrical performance first and appearance second, but appearance is how the component is inspected. A casting or moulding that hides voids, or one that shows mottling where the wall section changes, fails at inspection before it reaches an electrical test.

The colour paste in an insulating system has to meet three conditions. It must not introduce ionic species that lower resistivity, it must not interfere with the cure, and it must give enough contrast to make defects visible. In a switchgear component the shade also carries phase or type identification, so it has to be consistent across a production programme rather than merely acceptable part by part.

Electrical performance is measured on the finished part, but it is decided by what is in the resin. Ionic species left by a pigment or its carrier raise leakage current and lower resistivity, and the effect stays invisible until the part is tested. Tracking resistance depends on the surface remaining clean and uniform, which is a surface-finish question rather than a colour question. Where the shade carries phase identification, consistency across a production programme matters more than the exact shade, because the marking is read against a standard rather than in isolation.

Products for this route

Light Gray Paste

Used in insulating supports, transformer parts, insulators and switchgear components.

Full description under SMC and BMC Moulding

Light Gray 642C Paste

SMC/BMC grade carrying a Class A fire rating where the housing requirement demands it, used in insulating housings and structural parts.

Full description under SMC and BMC Moulding

RAL6012 Dark Green Paste

Used in insulating tie rods, insulators and switchgear components.

Full description under FRP Pultrusion and Profiles

Medium Gray Paste

Used in insulating paints, transformer paints, motor insulating paints and high-voltage protective paints.

Full description under Water-Based Coatings and Inks

Fluorescent Pigment Paste

Used in insulating profiles, insulators and switchgear components.

Full description under FRP Pultrusion and Profiles

Request Technical Data

Send us the resin system, application method and service conditions for electrical insulation and switchgear, and we will confirm the grade and the supporting data.