SMC and BMC Moulding
Light gray and fire-rated Class A pastes for SMC and BMC housings, sanitary ware, automotive parts and manhole covers.

SMC and BMC are compression moulded from a thickened sheet or a bulk charge with glass fibre already present. The mould runs hot and the cycle is short, so the paste has to disperse through a highly filled, fibre-bearing charge without disturbing the fibre distribution.
Two defects dominate: fibre exposure at the surface, and colour separation where the paste does not wet the fibre uniformly. Both are visible on the finished part and neither can be corrected after cure. In electrical housings the fire rating is an additional requirement that limits which pigment and carrier combinations are acceptable.
Compression moulding puts the charge under pressure at mould temperature, and the charge has to flow to fill the cavity before it gels. Fibre orientation follows that flow, so a paste that changes the viscosity of the charge changes where the fibre ends up. Class A surfaces are the demanding case: the surface has to hide the fibre underneath while remaining paintable, and any separation between paste and resin shows as a mottle that polishing will not remove. Fire-rated grades add a further constraint, because the additive package providing the rating has to remain effective after the pigment is introduced.
Products for this route
Light Gray Paste
Used in BMC/SMC electrical housings, meter boxes, switch panels, motor end caps and charging piles; SMC sanitary ware, artificial stone, bathroom cabinets and shower bases; injection composite parts, automotive parts, hardware fittings and fasteners; manhole covers, water grates, inspection wells and guardrail fittings; FRP gel coats and topcoats; and insulating supports, transformer parts, insulators and structural parts. It resolves fibre exposure, colour separation, mottling in sanitary ware and export compliance.
Request technical dataLight Gray 642C Paste (SMC/BMC dedicated, fire rating Class A)
Used in SMC electrical housings, meter boxes, switchgear, charging piles and end caps; SMC sanitary ware, artificial stone, laundry sinks and shower bases; automotive exterior parts, bumpers, deflectors, bus interiors and rail transit parts; manhole covers, water grates and inspection wells; insulating parts and transformer parts; and gel coats and topcoats. It addresses flooding and colour separation, fibre exposure, migration and tackiness, fire protection and water seepage.
Request technical dataAlso used in this route
Fluorescent Pigment Paste and Phthalocyanine Blue Paste are also used in BMC/SMC moulded insulating parts and sanitary ware; their full descriptions are given under FRP Pultrusion and Profiles. FRP Pultrusion and Profiles
Related Applications
Request Technical Data
Send us the resin system, application method and service conditions for smc and bmc moulding, and we will confirm the grade and the supporting data.