FRP Pultrusion and Profiles

Colour pastes for pultruded FRP profiles, cable trays, photovoltaic brackets, gratings and insulating rods.

Pultruded glass-reinforced profile emerging from a heated die on a pultrusion line

Pultrusion is a continuous process. The roving is pulled through a resin bath and then through a heated die, where the profile gels and cures before it leaves. Die temperature and line speed set the cure window, and a pigment that slows the cure or volatilises in the die produces streaks, exposed fibre and dimensional drift.

Colour in a pultruded profile is not only cosmetic. It identifies the product family, and in insulating profiles it carries type marking. The shade has to survive UV, moisture and the chemical exposure of the end application, which for a cable tray or a desulfurization component is not a mild environment.

The die is where a pultrusion is won or lost. Resin has to wet out every roving before the bundle enters the die, and inside the die the profile has to gel before it reaches the exit, or the surface drags and the fibre shows through. Surface finish is judged on the profile as it leaves the line, which means the pigment has to be fully dispersed before the resin bath rather than downstream. Because the profile is cut, drilled and assembled afterwards, colour that is only skin-deep is not enough; the shade has to be uniform through the wall.

Products for this route

Fluorescent Pigment Paste

Used in pultruded FRP pipes, profiles, gratings, photovoltaic brackets and cable trays; insulating profiles, insulators and switchgear components; and municipal guardrails, roadblocks and warning signs. It addresses darkening after high-temperature curing, colour differences, flow marks and crystal points, and low warning visibility in weak light.

Request technical data

RAL6012 Dark Green Paste

Used in pultruded FRP anti-corrosion profiles, cable trays, photovoltaic brackets, purlins and insulating rods; vinyl anti-corrosion profiles, pipe supports, desulfurization towers and electroplating components; FRP gratings, trench covers, car wash gratings and step boards; and insulating tie rods, insulators and switchgear. It resolves curing deformation, streaks, fibre exposure and colour differences, and fading.

Request technical data

Dark Brown Paste

Used in FRP round, square and special-shaped pipes, cable protection pipes and anti-corrosion pipes; cable trays, troughs, ladder trays and anti-corrosion purlins; walkway gratings, trench covers, tree grates and photovoltaic maintenance access; desulfurization towers, exhaust treatment and environmental equipment frames; and curtain wall profiles and antique building materials. It addresses high-temperature degradation, export colour deviation, streaks and fibre exposure.

Request technical data

UP800R Ultra-White Paste (titanium dioxide, Class A water resistance)

Used in fibreglass pultruded profiles, insulating rods, cable trays, purlins and photovoltaic brackets; FRP daylighting panels, translucent panels and clean room wall panels; and anti-corrosion profiles, water treatment parts, pool covers and corrosion-resistant gratings. It addresses greening and fibre exposure in pultrusion, colour reversion of white paste, and gel coat yellowing.

Request technical data

Phthalocyanine Blue Paste (heat resistance 300 °C, light fastness grade 8)

Used in pultruded anti-corrosion profiles, cable trays, photovoltaic brackets and insulating rods. It addresses fibre exposure and colour bands, flooding, colour bleeding and colour retention.

Request technical data

Related Applications

Request Technical Data

Send us the resin system, application method and service conditions for frp pultrusion and profiles, and we will confirm the grade and the supporting data.