High-Temperature Non-Silicone Leveling Agent

Non-silicone, 100% active leveling agent for baking systems that need recoatability and interlayer adhesion.

Coil coating roller line running coated steel strip inside a factory

In a high-temperature baking system the choice of leveling agent is limited first by recoatability. Silicone additives lower surface tension effectively, but residual silicone breaks intercoat adhesion, and in automotive refinish and coil systems where several coats are applied the result is biting and peeling.

This product is non-silicone and 100% active content. It is suitable for solvent-based and solvent-free systems and retains leveling performance under high-temperature baking.

Used in industrial baking paints and automotive refinish paints including hardware and appliance enamels, OEM automotive paints, repair paints and construction machinery coatings, where it provides good recoatability, strong interlayer adhesion without biting or peeling, and a smooth glossy film free of craters and pinholes. It also fits coil coatings for color steel and aluminum coils and pre-coated panels, ensuring full leveling under high-speed application and high-temperature curing without cracking during bending or stamping. Applied to can and container coatings for food and chemical cans, delivering smooth sanitary inner walls that withstand baking and sterilization without migration, and to printing inks such as gravure, screen and packaging inks, producing sharp burr-free dots with improved gloss and transfer performance.

Leveling is judged on the baked film rather than on the wet drawdown. At high bake temperatures the film viscosity drops quickly, so craters and pinholes that appear after cure are often traces of contamination or of a surface-tension difference that only shows once the film is fully crosslinked. In systems built up in several passes, check the recoated panel rather than the single coat.

At 100% active content there is no solvent carrier, so addition is calculated on resin solids. Overdosing pulls the film back from edges; start low and step up.

Discuss Your Application

Send the substrate, process and service conditions, and we will confirm whether this product fits or propose an alternative.

Discuss Your Application