Coil Coatings and Pre-Coated Panels
Spherical matting powder for colour steel coil coatings, pre-coated panels and metal decorating baking enamels.

Coil coating runs at line speeds that leave the film only seconds in the oven, and peak metal temperature is high. The film is thin, so surface defects are visible at once, and the coil is subsequently formed, profiled and cut, so the coating has to resist abrasion as well as meet appearance requirements.
Matting is one of the recurring demands: a controlled low gloss without the surface becoming rough enough to trap dirt or to interfere with the forming operation. A spherical matting agent reduces gloss while keeping the surface uniform, which is the difference between a matte finish that survives forming and one that shows marks after profiling.
Line speed and peak metal temperature decide the cure window, and neither can be extended for the convenience of one component. The film is also expected to keep its appearance after profiling, where the coating is stretched at bends and edges. Matting is the property most exposed to that sequence: a matte surface built from coarse particles can open up at a bend and read as a lighter streak, so particle shape rather than particle size alone is the selection criterion. Coil lines run continuously, which means a formulation that blocks or builds on the applicator roll stops the line rather than producing a single reject. Strip pre-treatment decides adhesion, and primer and topcoat are usually applied wet-on-wet before a single cure pass.
Products for this route
Matting Powder (spherical texture powder)
Used in colour steel coil coatings, metal decorating baking enamels and pre-coated panel coatings. The spherical particle shape distributes evenly in a thin film, reducing gloss without the roughness that angular matting agents leave behind. It addresses glare, glossy surfaces, plate blocking and burrs in printing, and wear and scratch resistance.
Request technical dataRelated Applications
Request Technical Data
Send us the resin system, application method and service conditions for coil coatings and pre-coated panels, and we will confirm the grade and the supporting data.